Synthesis, Characterization, and Formation Process of Na-X Zeolite from Coal Fly Ash

Using the SiO₂ and Al₂O₃ components of the amorphous phase in coal fly ash (Fa), Fa was converted to Na-X zeolites in NaOH-NaAlO₂ solutions by stirring at 35°C for 72 hr and then aging at 85°C for a given period. The molar ratio SiO₂/Al₂O₃ of the starting materials was controlled from 2.0 to 13.2. The resulting materials were characterized by various means. Increasing the SiO₂/Al₂O₃ ratio of the starting material increased the degree of crystallinity of faujasite, exhibiting a maximum at SiO₂/Al₂O₃ = 8.0. The faujasite formed was identified as Na-X zeolite with Si/Al = 1.20. The amorphous phase in Fa was dissolved during the stirring to form a precursor of zeolite, such as amorphous aluminosilicate. The Na-X zeolite was formed by aging for 24 hr, and the degree of crystallinity of this material was increased with the increasing aging period. The cation exchange capacity and specific surface area were increased with the increasing degree of crystallinity of the Na-X zeolites.     

基于BOOSt结构下不连续导电模式的PFC电路

采用现代高频功率变换技术的有源功率因数校正（Power Factor Corrector,PFC)技术是解决高频开关变换器谐波污染的有效手段。与传统的PFC电路相比，有源PFC电路的输入电流接近正弦波且与输与电压同相位，能有效抑制电流波形畸变和谐波，因此避免了对同一电网设施的干扰。在PFC电路中，Boost变换器是研究和应用得最多的一种变换器。本文着重分析了Boost电路在不连续导电模式状态下，PFC电路的临界条件，对实际电路结构的设计有很好的指导意义。     

Introduction of a nonlinearity measure for principal component models

Although principal component analysis (PCA) is an important tool in standard multivariate data analysis, little interest has been devoted to assessing whether the underlying relationship within a given variable set can be described by a linear PCA model or whether nonlinear PCA must be utilized. This paper addresses this deficiency by introducing a nonlinearity measure for principal component models. The measure is based on the following two principles: (i) the range of recorded process operation is divided into smaller regions; and (ii) accuracy bounds are determined for the sum of the discarded eigenvalues. If this sum is within the accuracy bounds for each region, the process is assumed to be linear and vice versa. This procedure is automated through the use of cross-validation. Finally, the paper shows the utility of the new nonlinearity measure using two simulation studies and with data from an industrial melter process.     

软件构件技术在管理信息系统中的应用

软件构件技术是一种前沿的软件设计思想，其方法与传统的软件制作方法有很大区别．通过介绍软件构件技术在开发管理信息系统的应用，与其它软件制作方法进行比较，得出这样的结论：在软件编制中应用这种思想，不仅能大幅度地加快软件的开发速度，而且对整个软件行业的发展有着至关重要的推动作用。     

过氧化甲乙酮合成研究

论述了过氧化甲乙酮的合成方法，用阳离子交换树脂催化剂代替传统的无机酸催化剂。考察了离子交换树脂用量、反应温度对反应产率、活性氧含量的影响及溶剂对产品稳定性的影响。     

通信局房供电系统的谐波治理

本文在理论分析谐波产生及危害的基础上,针对某一通信局房,确定最终谐波治理方案并取得较好的治理效果,供同行在设计时参考。     

阴离子表面活性剂测定方法的探讨

本文对“阴离子表面活性剂的测定方法”进行探讨,优化了显色剂、萃取剂的用量及萃取频率等分析条件,有效地降低了方法的检出浓度,提高了分析精度及准确度,节约大量试剂。本法最低检出浓度的0.019mL/L。     

加氢处理润滑油基础油各组分对光安定性的影响

将经紫外光照前后的加氢处理润滑油基础油分离为饱和烃、轻质芳烃、中质芳烃、重质芳烃和极性组分，分别采用薄层色谱、质谱和紫外吸收光谱分析了各组分的烃组成、硫和氮含量的变化，并通过将从原料油中分离出的各组分反加到光安定性好的饱和烃中，试验验证了加氢处理润滑油基础油中的重质芳烃和极性组分是光不安定组分，其中含有硫、氮的芳香杂环化合物光安定性差。     

几种OLED有源驱动电路中像素单元电路的分析

在有机电致发光器件两管单元有源驱动电路的基础上．分析了几种四管单元电流控制型和电压控制型的驱动电路，它们都能补偿TFT阈值电压的漂移．但都有各自的优缺点：前者能准确地调节显示的灰度，但它的响应速度慢；后者的响应速度快，但不能准确地调节显示的灰度。